Site Information

 Loading... Please wait...

Tectyl 502C Class I | 1 Pint Can

Tectyl 502C Class I | 1 Pint Can

/ 3114125

0 Stars Write a review

2.00 LBS
View Additional Sizes


Product Description

Tectyl 502C, Class I, 1 Pt. can, is a solvent cutback, corrosion preventive compound designed to protect ferrous and non-ferrous parts for indoor or covered storage and during shipment.

The semi-firm film is amber and translucent and is approved under Military Specifications MIL-PRF-16173E, Grade 2, for Class I, and MIL-P-116J, Type P-2. The cured film is compatible with a variety of oils and greases. 

Tectyl 502C, Class I is the ultimate protection for manufactured cast and forged steel roles used in various rolling industries.

Surface Preparation:The maximum performance of this product can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale.
This product is formulated to be used as supplied.

✓ - Ensure uniform consistency prior to use.
✓ - Continued stirring is generally not required.
✓ - If product thickens, contact Daubert Chemical Company.*
✓ - Ambient/product temp at time of application: 50 - 95F.**
✓ - This product can be spray or dip applied.

  • Coating can be removed with Tectyl HPS solvent-borne thinner, vapor degreasing, hot alkaline wash, or low pressure steam.
  • It can be removed from fabrics by normal dry cleaning procedures.
  • Avoid the use of chlorinated or highly aromatic solvents when removing from painted surfaces, as these solvents may adversely affect paint.


  • Store product at temperatures between 50-95F (10-35C).
  • Mild agitation is recommended prior to use.


CAUTION: Adequate ventilation is required for cure and to ensure against formation of a combustible liquid. The partially cured film should not be exposed to ignition sources such as flares, flames, sparks, excessive heat, or torches. Refer to Daubert's Safety Data Sheet for additional handling and first aid information.

NOTE:The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.

*This may occur due to cold storage or loss of solvent during use
**Or, 10 - 35C according to Daubert Chemical Company recommendations.

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!