Tectyl 900 | 54 Gallon Drum

Tectyl 900 | 54 Gallon Drum
(No reviews yet)
PRICE:
$1,064.02
SKU:
3022045
WEIGHT:
437.00 LBS



Tectyl 900 is a water displacing, low viscosity lubricating oil and corrosion preventive compound intended to provide protection to ferrous and non-ferrous industrial parts during storage and covered transit. This product is approved under Federal Specification MIL-PRF-32033, QPL Reference Number LP-7062.Surface Preparation:The maximum performance of this product can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale. Daubert Chemical Company recommends that the metal substrate temperature be 50-95F (10-35C) at the time of product application. 

Tectyl 900 is an approved refrigeration compressor parts coating that is compatible with FREON 12 and FREON 22.

Application:

This product is formulated to be used as supplied.

✓ - Ensure uniform consistency prior to use.
✓ - Continued stirring is generally not required.
✓ - If product thickens, contact Daubert Chemical Company.*
✓ - Ambient/product temp at time of application: 50 - 95F.**
✓ - This product can be spray or dip applied.
✓ - DO NOT THIN.
Removal:

  • Coating can be removed with Tectyl HPS solvent-borne thinner, vapor degreasing, hot alkaline wash, or low pressure steam.
  • It can be removed from fabrics by normal dry cleaning procedures.
  • Avoid the use of chlorinated or highly aromatic solvents when removing from painted surfaces, as these solvents may adversely affect paint.

Storage:

  • Store product at temperatures between 50-95F (10-35C).
  • Mild agitation is recommended prior to use.

 

CAUTION: Adequate ventilation is required for cure and to ensure against formation of a combustible liquid. The partially cured film should not be exposed to ignition sources such as flares, flames, sparks, excessive heat, or torches. Refer to Daubert's Safety Data Sheet for additional handling and first aid information.

NOTE:The addition of any product over or under this coating is not recommended. The use of additional coatings could result in chemical incompatibility, thus adversely affecting the performance of this coating as stated in the lab data section. If a product other than Daubert Chemical Company's recommended product is required, written authorization must be obtained from Daubert Chemical Company, Inc.


*This may occur due to cold storage or loss of solvent during use
**Or, 10 - 35C according to Daubert Chemical Company recommendations.

National Stock Number (NSN): 9150-00-281-2060

There aren't any reviews yet. Write a Review.

The Dark Horse of the Petroleum Industry
What is Rust (and how can you stop its reign of terror)?

Customers Also Viewed

Safety Data Sheet
Product Data Sheet
Refrigeration Approval

Due to these products being hazardous, an additional shipping charge of $25.00 is automatically added to all Ground Shipments. If you are able to order any combination of products that makes your total cart weight over 150 lbs, this additional fee is waived. This can equate to considerable savings on shipping.